ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
37
Green Spot Enable
Enables/disables the ability of the scanner to display a green spot after decoding a label
while in presentation mode.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You will need to cover any unused
barcodes on this and the facing page to ensure that the scanner reads only the bar-
code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Green spot disabled
Green spot enabled
040B00
040B01
To Next Page
Loading...
