PRODUCT REFERENCE GUIDE
53
INTERFACE SELECTION
INTERFACE TYPE
Specifies the current scanner interface.
NOTE
The correct interface cable is generally included for the reader interface
type you ordered.
NOTE
If the scanner’s interface type must be changed, always be sure that inter-
face configuration is the FIRST item scanned during a programming ses-
sion. (Selecting an interface type resets ALL other configuration items to
the factory default for that interface type.)
CAUTION
Great care should be taken to select the correct interface type, since you
can cause damage to the scanner and/or POS terminal by attempting to
change to an incompatible interface. ALWAYS make interface selections
with the host cable DISCONNECTED.
NOTE
When an interface is selected, the scanner loads the configuration for that
interface as the selection is made. Any custom configurations done in the
previous interface will not be carried over to the configuration for the new
interface.
To Next Page
Loading...
