USB INTERFACE FEATURES ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
61
USB Keyboard Intercharacter Delay
Specifies a time delay between characters.
To set this feature:
1. Scan the Set USB Keyboard Intercharacter Delay
barcode below.
2. Scan the appropriate characters/digits from the
Alpha-Numeric Keypad in Appendix C
that represent the desired delay. The selectable range for this option is any decimal
value from 00 (no delay) to 99 in 10 ms increments. A table containing the ASCII Char-
acter Set and their corresponding decimal values is available in the inside back cover
of this manual. ASCII parameters must be input by scanning decimal digits for each
character. Pad all single digit numbers with leading zero to yield a two-digit entry (00-
99). Thus, to set an intercharacter delay of 70ms, barcodes containing the digits ‘0’
and ‘7’ must be scanned.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
USB Keyboard Country Mode = Russian
USB Keyboard Country Mode = Brazilian Portuguese
USB Keyboard Country Mode = Vietnamese
030215 (CR)
030216\r
0x17(CR)
Set USB Keyboard Intercharacter Delay
Default setting for this feature is: 00 (1ms)
0287(CR)
DEFAULT
To Next Page
Loading...
