ENTER/EXIT PROGRAMMING MODE
70
MAGELLAN™ 900I
RS-232 Hardware Control
Enables/disables use of the RS-232 CTS signal for flow control and/or scan control.
Options are:
• Disable — The scanner transmits to the host regardless of any activity on the CTS line.
• Enable CTS Flow Control — The CTS signal controls transmission of data to the host.
• Enable CTS Scan Control — The CTS line must be active for scanner to read and trans-
mit data. While the CTS line is inactive, scanner remains in a host- disabled state; fol-
lowing a successful label transmission, the CTS signal must transition to inactive and
then to active to enable scanning for the next label.
• Enable Magellan SL CTS Scan Control — Follows the same hardware protocol as older
Magellan SL scanners.
RS-232 Hardware Control = Disable
RS-232 Hardware Control = Enable CTS Flow Control
RS-232 Parity = Enable CTS Scan Control
RS-232 Hardware Control = Enable MGL SL CTS Scan
Control
DEFAULT
020F00(CR)
020F01(CR)
020F02(CR)
020F03(CR)
To Next Page
Loading...
