RS-232 INTERFACE FEATURES ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
71
RS-232 Software Flow Control
Enables/disables RS-232 Flow Control using XON/ XOFF characters.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
This item will be ignored when the feature, RS-232 NAK Character, is
enabled
RS-232 Software Flow Control= Disable
RS-232 Software Flow Control= Enable
DEFAULT
002100(CR)
002101(CR)
To Next Page
Loading...
