Datalogic MAGELLAN 900i - ACK NAK Features; ACK NAK Enable

RS-232 INTERFACE FEATURES ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 73
RS-232 ACK NAK Features
ACK NAK
Enable
This enables/disables the ability of the scanner to support the RS-232 ACK/NAK protocol.
When configured, the scanner and/or host sends an “ACK” when it receives data properly,
and sends “NAK” when the data is in error. Selections for this option are:
• Disable ACK NAK
• Enable for Label Transmission — the scanner expects an ACK/NAK response from the
host when a label is sent)
• Enable for Host Acknowledgement — Enabled for Host Commands (the scanner will
respond with ACK/NAK when the host sends a command)
• Enable for Label & Host — Enabled for both Label Transmission & Host Command
acknowledgement.
To select the option for RS-232 ACK NAK Enable:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the desired option from barcodes below and on the following page. You’ll need
to cover any unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
RS-232 ACK NAK = Disable
RS-232 ACK NAK = Enable for Label Transmission
RS-232 ACK NAK = Enable for Host Acknowledgement
RS-232 ACK NAK = Enable for Label & Host
DEFAULT
061100(CR)
061101(CR)
061102(CR)
061103(CR)