Datalogic MAGELLAN 900i - Label ID; Label ID Control

ENTER/EXIT PROGRAMMING MODE
86 MAGELLAN™ 900I
LABEL ID
Label ID Control
This feature specifies whether or not Label IDs are transmitted to the host and if so,
whether to attach them as a prefix or suffix.
Choices are:
• Disable
• Enable as a Prefix
• Enable as a Suffix
To select the option for Label ID Control:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the desired option from the barcodes below. You’ll need to cover any unused
barcodes on this and the facing page to ensure that the scanner reads only the bar-
code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
Label ID Control = Disable
Label ID Control = Enable as a Prefix
Label ID Control = Enable as a Suffix
020500(CR)
020501(CR)
DEFAULT
020502(CR)