Datalogic Magellan 9800i - Double Read Timeout

Enter/Exit Programming Mode
114 Magellan™ 9800i Scanner
2D Double Read Timeout
The 2D Double Read Timeout feature specifies the minimum allowable time which must pass
before reading the same 2D label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
NOTE
03DF1E(CR)
2D Double Read Timeout = 300ms
03DF28(CR)
2D Double Read Timeout = 400ms
03DF3C(CR)
2D Double Read Timeout = 600ms
DEFAULT
03DF46(CR)
2D Double Read Timeout = 700ms
03DF50(CR)
2D Double Read Timeout = 800ms
If the incidence of multiple reads is not acceptable, increase the Timeout
setting to a higher value.