Datalogic Magellan 9800i - Good Read LED Idle State

Enter/Exit Programming Mode
120 Magellan™ 9800i Scanner
Good Read LED Idle State
This feature specifies the state of the green scanner LEDs when the scanner is idle and ready to
read a label. Options are:
•Off
•On dim
To set the Scanner LEDs Idle State:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
030101(CR)
Scanner LED Idle State = Off
030102(CR)
Scanner LED Idle State = On Dim
DEFAULT