Datalogic Magellan 9800i - Power-Up Tone Control

Enter/Exit Programming Mode
122 Magellan™ 9800i Scanner
Power-up Tone Control
Specifies the type of audible indication that is made when entering scanner-active mode on
power-up. Choices are:
•No tone
•Play tone
To set the Power-up tone:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
020700(CR)
Power-up Beep Control = No Tone
020701(CR)
Power-up Beep Control = Play Tone
DEFAULT