Enter/Exit Programming Mode
Product Reference Guide
123
Good Read Beep Control
This feature enables/disables scanner beep upon successfully decoding of a label.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
Good Read Beep Control = Disable
Good Read Beep Control = Enable
To Next Page
Loading...
