Datalogic Magellan 9800i - Good Read Beep Frequency

Enter/Exit Programming Mode
124 Magellan™ 9800i Scanner
Good Read Beep Frequency
Adjusts the scanner’s good read beep to sound at low, medium, or high frequency (controls the
beeper’s pitch/tone).
•Low
•Medium
•High
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
001400(CR)
Good Read Beep Frequency = Low
001401(CR)
Good Read Beep Frequency = Medium
DEFAULT
001402(CR)
Good Read Beep Frequency = High