Enter/Exit Programming Mode
138
Magellan™ 9800i Scanner
Scale Calibration Notification
This option enables a notification that scale calibration has taken place.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
Scale Calibration Notification = Disable
Scale Calibration Notification = Enable
To Next Page
Loading...
