Datalogic Magellan 9800i - PIR;CT Auxiliary Port Baud Rate

Enter/Exit Programming Mode
144 Magellan™ 9800i Scanner
PIR/CT Auxiliary Port Baud Rate
This feature specifies the baud rate of the auxiliary port when operating in PIR/CT Mode.
NOTE
This setting is valid ONLY when Auxiliary Port Mode is set to PIR/CT +
Diagnostics Reporting.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes on this and
the facing page to ensure that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar code.
051604(CR)
PIR/CT Auxiliary Port Baud Rate = 1200
051603(CR)
PIR/CT Auxiliary Port Baud Rate = 2400
051602(CR)
PIR/CT Auxiliary Port Baud Rate = 4800
051601(CR)
PIR/CT Auxiliary Port Baud Rate = 9600
DEFAULT
051600(CR)
PIR/CT Auxiliary Port Baud Rate = 19200
051606(CR)
PIR/CT Auxiliary Port Baud Rate = 38400