Datalogic Magellan 9800i - USB Interface Selection

Enter/Exit Programming Mode
166 Magellan™ 9800i Scanner
USB Interface Selection
Remember to cover any unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
CAUTION
NOTE
000145(CR)
Interface Type = USB OEM
00010D(CR)
Interface Type = USB TEC
000147(CR)
Interface Type = USB COM
Single cable installations require connection at the POS Terminal (host)
port. The Scale Host port connection is not used for this interface.
Great care should be taken to select the correct interface type, since you
can cause damag
e to the scanner and/or POS terminal by attempting to
change to an incompatible interface. ALWAYS make interface selections
with the host cable DISCONNECTED.