Enter/Exit Programming Mode
172
Magellan™ 9800i Scanner
IBM Transmit Labels in Code 39 Format
This feature enables/disables scanner's ability to set a symbology identifier for a specified label to
Code 39 before transmitting that label data to an IBM host. This applies to: Code 128, Code 93
and Codabar for IBM Port 5B; Code 93 and Codabar for IBM Port 9B; Code 128, Code 93
and Codabar for OEM-USB.
NOTE
When enabled, this feature has no effect on
IBM Port 17.
To enable/disable the IBM Transmit Labels in Code 39 Format feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
IBM Transmit Labels in Code 39 Format = Disable
IBM Transmit Labels in Code 39 Format = Enable
To Next Page
Loading...
