Datalogic Magellan 9800i - Number of Stop Bits

Enter/Exit Programming Mode
Product Reference Guide 181
RS-232 Number of Stop Bits
Specifies number of stop bits required for sending and receiving data.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below representing the desired Stop Bit setting. You’ll need to cover any
u
nused barc odes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
002200(CR)
RS-232 Number of Stop Bits = 1
002201(CR)
RS-232 Number of Stop Bits = 2