Enter/Exit Programming Mode
Product Reference Guide
185
RS-232 Software Flow Control
Enables/disables RS-232 Flow Control using XON/ XOFF characters.
NOTE
This item will be ignored when the feature, RS-232
NAK Character, is enabled
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
RS-232 Software Flow Control= Disable
RS-232 Software Flow Control= Enable
To Next Page
Loading...
