Datalogic Magellan 9800i - Beep on Not on File

Enter/Exit Programming Mode
Product Reference Guide 191
Beep on Not on File
Select for the host to beep (or not) when a not-on-file condition is detected by the host. This
feature is also applicable to single cable RS-232.
Options for this feature are:
• Muted (no beep will sound)
•Low Volume
• Medium Volume
•High Volume
To configure this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code for the desired selection below. You’ll need to cover any unused bar
codes on this and th
e facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
045100(CR)
RS-232 Beep on Not on File = Muted
045101(CR)
RS-232 Beep on Not on File = Low Volume
DEFAULT
045102(CR)
RS-232 Beep on Not on File = Medium Volume
045103(CR)
RS-232 Beep on Not on File = High Volume