Enter/Exit Programming Mode
Product Reference Guide
193
RS-232 ACK Character
This feature specifies which ASCII character will be used as an ACK character.
NOTE
DO NOT set this feature to use previously defined characters such
as XON, XOFF or host commands as this will conflict with normal
operation of these characters. 8-bit data is not recognized when
the feature, RS-232 Number of Data Bits, is set to 7 data bits.
To specify the RS-232 ACK Character:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, SET RS-232 ACK Character below. You’ll need to cover any unused
bar codes on this and
the facing page to ensure the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the
Keypad in Appendix C that represent the hex desig-
nation for the desired character. A table containing the ASCII Character S
et and their cor-
responding Hex Values is available in the inside back cover of this manual. ASCII
param
eters must be input by scanning a pair of hexadecimal digits for the desired charac-
ter. For example, if ASCII “A” were the desir
ed ACK character, you would scan the digits
“4”, then “1” (the ASCII corresponding hex value).
4. The scanner will automatically exit Programming M
ode when the appropriate amount of
digits/characters have been scanned.
Set RS-232 ACK Character
DEFAULT
Default setting for this feature is:
06 - ACK
To Next Page
Loading...
