Datalogic Magellan 9800i - Retry on ACK NAK Timeout

Enter/Exit Programming Mode
Product Reference Guide 195
RS-232 Retry on ACK NAK Timeout
This option specifies the action scanner performs on expiration of the RS-232 ACK NAK
Timeout Value.
Options are:
• Disable (transmission failure occurs)
•Enable (retry)
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
032100(CR)
RS-232 Retry on ACK NAK Timeout = Disable
032101(CR)
RS-232 Retry on ACK NAK Timeout = Enable
DEFAULT