Enter/Exit Programming Mode
Product Reference Guide
199
RS-232 Indicate Transmission Failure
This feature enables / disables the ability of the scanner to sound a bad label beep indication
when a transmission failure occurs.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired option from the bar codes be
low. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
RS-232 Indicate Transmission Failure = Disable
RS-232 Indicate Transmission Failure = Enable
To Next Page
Loading...
