Datalogic Magellan 9800i - Single Cable RS-232 Use ACK;NAK

Enter/Exit Programming Mode
Product Reference Guide 205
Single Cable RS-232 Use ACK/NAK
Enables/disables the ability of the scanner to use ACK/NAK.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
047E00(CR)
Single Cable RS-232 Use ACK/NAK = Disable
047E01(CR)
Single Cable RS-232 Use ACK/NAK = Enable