Enter/Exit Programming Mode
Product Reference Guide
213
Keyboard Wedge No Keyboard Support
Enables the scanner to perform host communications normally performed by an attached
keyboard.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
Keyboard Wedge No Keyboard Support = Disable
Keyboard Wedge No Keyboard Support = Enable
To Next Page
Loading...
