Datalogic Magellan 9800i - USB Keyboard and Keyboard Wedge Send Control Characters

Enter/Exit Programming Mode
214 Magellan™ 9800i Scanner
USB Keyboard and Keyboard Wedge Send Control Characters
This feature specifies how the scanner transmits ASCII control characters to the host.
NOTE
Affects suffix and prefix characters. When disabled, only ASCII
characters between 20H and 127H inclusive (space... delete) plus
special characters 0DH (carriage return), 08H (backspace), 27H
(ESC), 09H (right tab) and 0BH (left tab) are transmitted.
Choices are:
Disable — No control characters are sent to the host.
Enable transmission of control characters to host — Control characters are sent to the host.
Send characters between 00H and 1FH — Send characters between 00H and 1FH according to
special function-key mapping table (This is used to send keys that are not in normal ASCII set;
a unique set is provided for each available scancode set)
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code for the desired setting below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
02C500(CR)
Keyboard Send Control Characters = Disable
02C501(CR)
Keyboard Send Control Characters =
Enable transmission of control characters to host
02C502(CR)
USB Keyboard/Keybd Wedge No Keyboard Support =
Send characters between 00H and 1FH