Datalogic Magellan 9800i - Coupon Control

Enter/Exit Programming Mode
236 Magellan™ 9800i Scanner
Coupon Control
This feature is used to control the method of processing coupon labels. For the puposes of this
feature, coupon labels are defined as:
1. UPC-A labels that start with a ‘5’
2. GS1 DataBar Expanded labels that start with ‘8110’
The options for this setting are:
• Disable — Coupon Control is turned off.
• Enable UPC-A Coupons — UPC-A coupon labels will decode but GS1 D
ataBar
Expanded coupon labels will not. GS1 DataBar Expanded labels that are not coupon
labels will decode and all UPC-A labels will decode.
• Enable GS1 DataBar Expanded Coupons — GS1 DataBar Expanded coupon labels will
decode
but UPC-A coupon labels will not. UPC-A labels that are not coupon labels will
decode and all GS1 DataBar Expanded labels will decode.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your choice from the Coupon Control selections below. You’ll need to cover any
u
nused bar codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
03B900(CR)
Coupon Control = Disable
03B901(CR)
Coupon Control = Enable UPC-A Coupons
DEFAULT
03B902(CR)
Coupon Control = Enable GS1 DataBar Expanded
Coupons