Enter/Exit Programming Mode
Product Reference Guide
257
EAN-8 Guard Insertion
This setting enables the insertion of either a missing leading or trailing guard to a scanned bar
code.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
EAN-8 Guard Insertion = Disable
EAN-8 Guard Insertion = Enable
To Next Page
Loading...
