Datalogic Magellan 9800i - In-Store Printed Label Minimum Read

Enter/Exit Programming Mode
262 Magellan™ 9800i Scanner
In-Store Printed Label Minimum Read
This feature specifies the minimum number of consecutive In-Store Printed Label decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
008501(CR)
In-Store Printed Label Minimum Read = 1
008502(CR)
In-Store Printed Label Minimum Read = 2
008503(CR)
In-Store Printed Label Minimum Read = 3
008504(CR)
In-Store Printed Label Minimum Read = 4