Datalogic Magellan 9800i - UPC;EAN Minimum Segment Length

Enter/Exit Programming Mode
268 Magellan™ 9800i Scanner
UPC/EAN Minimum Segment Length
This feature specifies the minimum number of characters needed in a UPC/EAN segment in
order to be accepted for decoding.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code for the desired setting below. You’ll need to cover any unused bar codes
on this and
the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
DEFAULT
048F05(CR)
UPC/EAN Minimum Segment Length = 5 Characters
048F06(CR)
UPC/EAN Minimum Segment Length = 6 Characters
048F07(CR)
UPC/EAN Minimum Segment Length = 7 Characters
048F08(CR)
UPC/EAN Minimum Segment Length = 8 Characters
048F09(CR)
UPC/EAN Minimum Segment Length = 9 Characters