Enter/Exit Programming Mode
272
Magellan™ 9800i Scanner
Enable EAN Two Label
Enables/disables the ability of the scanner to decode EAN two-label pairs.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning the
Enter/Exit Programming Mode bar
code.
NOTE
DEFAULT
EAN Two Label = Disable
EAN Two Label = Enable
Contact Customer Support for details about advanced programming
for this feature.
To Next Page
Loading...
