Datalogic Magellan 9800i - Code 128 Minimum Read

Enter/Exit Programming Mode
Product Reference Guide 311
Code 128 Minimum Read
This feature specifies the minimum number of consecutive Code 128 decodes before is accepted
as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this
and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
006F01(CR)
Code 128 Minimum Read = 1
006F02(CR)
Code 128 Minimum Read = 2
006F03(CR)
Code 128 Minimum Read = 3
006F04(CR)
Code 128 Minimum Read = 4