Enter/Exit Programming Mode
316
Magellan™ 9800i Scanner
Code 128 Stitching
Enables/disables stitching for Code 128 labels. When parts of a Code 128 barcode are presented
to the scanner with this feature enabled, the barcode parts will be assembled by the scanner’s
software, and the data will be decoded if all barcode proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below.
You’ll need to cover any unused barcodes on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
Code 128 Stitching = Disable
Code 128 Stitching = Enable
To Next Page
Loading...
