Enter/Exit Programming Mode
328
Magellan™ 9800i Scanner
Codabar Start Stop Character Transmission
Enables/disables transmission of Codabar start and stop characters.
NOTE
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
Codabar Start Stop Character Transmission = Disable
Codabar Start Stop Character Transmission = Enable
To Next Page
Loading...
