Enter/Exit Programming Mode
350
Magellan™ 9800i Scanner
MSI Check Character Transmission
Enables/disables transmission of optional MSI check characters.
NOTE
This feature applies only when
MSI Check Character Calculation
is
enabled. This item is ignored when the advanced feature, Full Label
Edit
, is enabled.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
MSI Check Character Transmission = Disable
MSI Check Character Transmission = Enable
To Next Page
Loading...
