Datalogic Magellan 9800i - Standard 2 of 5 Check Character Transmission

Enter/Exit Programming Mode
Product Reference Guide 359
Standard 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Standard 2 of 5 check character.
NOTE
This feature applies only when Standard 2 of 5 Check Character
Calculation
is enabled. This item is ignored when the advanced fea-
ture, Full Label Edit, is enabled.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused barcodes
on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
049B00(CR)
Standard 2 of 5 Check Character Transmission = Disable
049B01(CR)
Standard 2 of 5 Check Character Transmission = Enable
DEFAULT