Enter/Exit Programming Mode
Product Reference Guide
365
Standard 2 of 5 Stitching
Enables/disables stitching for Standard 2 of 5 labels. When parts of a Standard 2 of 5 barcode
are presented to the scanner with this feature enabled, the barcode parts will be assembled by the
scanner’s software, and the data will be decoded if all barcode proofing requirements are met.
NOTE
This applies when
Standard 2 of 5 Length Control
is set to fixed-
length decoding.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below. You’ll need to cover any unused barcodes on
this
and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
DEFAULT
Standard 2 of 5 Stitching = Disable
Standard 2 of 5 Stitching = Enable
To Next Page
Loading...
