Datalogic Magellan 9800i - QR Code Length Control

Enter/Exit Programming Mode
380 Magellan™ 9800i Scanner
QR Code Length Control
Fixed Length Decoding — When fixed length decoding is enabled, the scanner will decode a bar
code if the label length matches one of the configurable fixed lengths.
Variable Length Decoding — When variable length decoding is enabled, the scanner will
decode a ar code if the label length falls in the range of the configurable minimum and
maximum length.
Configuring Fixed Length Decoding:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the Fixed Length Decoding bar code.
3. Scan the ENTER/EXIT Programming Mode bar code.
4. Set Length 1 to the first fixed length using the
QR Code Length 1, Length 2 Program-
ming Instructions
that follow this page.
5. Set Length 2 to the second fixed length (or to ‘00
00’ if there is only one fixed length)
using the
QR Code Length 1, Length 2 Programming Instructions.
Configuring Variable Length Decoding:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the Variable Length Decoding bar code.
3. Scan the ENTER/EXIT Programming Mode bar code.
4. Set Length 1 to the minimum length using the
QR Code Length 1, Length 2 Program-
ming Instructions
that follow this page.
5. Set Length 2 to the maximum length using the
QR Code Length 1, Length 2 Program-
ming Instructions
.
DEFAULT
03D900(CR)
QR Code Length Control = Variable Length
03D901(CR)
QR Code Length Control = Fixed Length