Datalogic Magellan 9800i - Aztec Length 1, Length 2 Programming Instructions

Enter/Exit Programming Mode
Product Reference Guide 387
Aztec Length 1, Length 2 Programming Instructions
If Aztec Length Control is set to Fixed-Length decoding, this feature specifies Aztec first fixed
length. If Aztec Length Control is set to Variable-Length decoding, this feature specifies the
minimum label length.
NOTE
Length 1 is the minimum label length if in variable length mode, or
the first fixed length if in fixed length mode. Length 2 is the maxi-
mum label length if in variable length mode, or the second fixed
length if in
fixed length mode. Length includes the barcode's data
characters only. Any value > 3700 will be considered to be 3700.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode,
Set Aztec Length 1 or Set Aztec Length 2 below. You’ll need to cover
any unused barcodes on this and the facing page to ensure that the scanner reads only the
bar
code you intend to scan.
3. Scan the appropriate digits from the
Keypad in Appendix C that represent the desired
label length. The selectable range for this option is 00
01 to 3700. Pad all numbers with
leading zeros to yield a four-digit entry (0001-3700).
4. Complete the programming sequence by scanning
the ENTER/EXIT Programming
Mode bar code.
Default setting for this feature = 0001
0433(CR)
Set Aztec Length 1
0434(CR)
Set Aztec Length 2
Default setting for this feature = 3700