EasyManua.ls Logo

Datalogic Magellan 9800i - Page 404

Datalogic Magellan 9800i
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
392
Magellan™ 9800i Scanner
Audio Indications
The speaker (beeper) mounted in the scanner’s bonnet will beep or sound other audio
indications to announce scanning, weighing, errors or other functions (see Table 16). Beep
indications specific to Electronic Article Surveillance
(EAS) are listed in the next section.
NOTE
Table 16. Audio Indications
AUDIO
INDICATION
DESCRIPTION OF SOUND COMMENT
Power-up tone
Unique WAV file sound. Synthesized
t
ones ending with two bell sounds.
Indicates the scanner is powering-on.
Good Read Beep
One beep at current frequency and
vo
lume.
The duration of the beep is also at the current setting.
ROM Failure
One 200ms error beep at low fre-
quency.
Indicates Boot ROM or Program ROM failure.
Chirp Indications
Six “Chirps” at highest frequency and
cu
rrent volume.
A “Chirp” is used to indicate the following:
-Reading labels while in limited scanning mode.
-Label rejection during label programming.
-A label with no data.
-Labels rejected through the auxiliary port when in
Scanner Diagnostics Mode.
Bootload Entry
Indications
The beeper sounds a series of beeps at
hig
hest frequency and current volume
to indicate various
See Error Codes in the Problem Isolation section for
more details.
Null Interface
Sel
ected
40 error beeps at highest volume,
20ms ON and 20 ms OFF.
This means that no interface has been selected. Refer to
the Programming section for interface configuration
information.
Insert microSD Card
Unique WAV file sound. Similar to a
high-pit
ched plucked string.
This sound occurs upon a microSD Car
d being installed in
the microSD slot. Click the icon in the left column to hear
the sound.
Eject microSD Card
Unique WAV file sound. Similar to a
med
ium-pitched plucked string.
Indicates that a microSD Card has been removed from the
micr
oSD Card slot. Click the icon in the left column to hear
the sound.
The indications listed below are the factory default settings.
Your scanner may have been configured with different beeper
settings. For example, certain beeper indications may be
turned off.

Table of Contents

Other manuals for Datalogic Magellan 9800i

Related product manuals