398
Magellan™ 9800i Scanner
Calibration Switch
This switch initiates the scale’s calibration routine. A certified weight set is needed to perform
the scale calibration steps detailed in Chapter 6, Calibration Procedures. This switch is not
included in scanners without scale modules.
Calibration Switch Seal
This seal allows you to secure the Calibration Switch access cover and restrict access to the
Calibration Switch. If the calibration seal is broken or missing, you may be prohibited from
operating the scale without recertification. Check local and state requirements for specific
restrictions.
Calibration Switch Cover
This cover restricts access to the Calibration Switch to help guard against unauthorized
tampering when sealed. See Figure 59.
LEGAL NOTE
There are regulations that must be followed in order to ensure compli-
ance when operating a weighing devic
e such as the scanner/scale. Fail-
ure to observe and comply with these regulations could result in legal
ac
tion.
Figure 59. Calibration Switch Cover
A
B
C
To Next Page
Loading...
