Product Reference Guide
43
Remote Display Cabling
Your installation should also take into account the routing of Remote Display cabling. Ensure
that distance and obstacles spanned by the routed cable will not kink, pinch or stretch it. Also
keep in mind you may need to drill a hole through which to route it.
NOTE
The Remote Scale Display connector end may be secured with a rubber
band during shipping to prevent damage to the “locking tabs”. After
routing the cable, remove this rubber band before connecting. Failure to
remove the band will keep the connector from latching properly.
Placing and Installing the Remote Display
Reference Figure 29 while performing these procedures.
1. Determine where you want to install the Remote Scale Display based on your counter
de
sign, the viewing angle, lighting considerations and cable routing discussed previously.
Reference
Figure 28 for the display’s physical dimensions. Optimally, the display(s)
should be approximately eye level to the viewer(s).
2. Use the template provided in
Figure 30 to mark locations of the mounting screw and
cable routing holes.
• The mounting screw holes are on 3-1/2” (85.1 mm) centers. The cable can either be
rout
ed through a
3
/4” (19 mm) diameter hole directly under the mounting base or
through the cutout in the back of the base (see
Figure 29).
3. Drill the mounting screw holes using a drill
bit of the appropriate diameter for your
mounting screws or bolts.
4. Drill the cable routing hole using a
3
/4” (19 mm) drill bit (optional).
Figure 28. Remote Display Physical Measurements
18.5mm
28.4mm
Dual Display Single Display
329mm
325mm
292.5mm
227.5mm
116.39mm
112mm
60mm
264mm
116.39mm
112mm
60mm
25.5mm
85.1mm
41.99mm
To Next Page
Loading...
