Site Preparation and Installation
44
Magellan™ 9800i Scanner
5. Feed the entire length of the Remote Scale Display interface cable through the cable rout-
ing hole so that the assembled Remote Scale Display can be positioned over the mounting
scr
ew holes.
6. If present, remove the rubber band from the connector end.
7. Install mounting screws or bolts to complete the installation of the Remote Scale Display.
T
ake care not to pinch or pierce the interface cable while securing the Remote Scale Dis-
play to the checkstand.
Figure 29. Remote Scale Display Mounting
48 - 60"
(122 - 152cm)
36"
(91cm)
11.5"
(29cm)
24"
(61cm)
Mounting
Example
(optional
cable
routing)
Dual Display
Heads
Single
Display
Head
Figure 30. Remote Scale Display Mounting Template
25.5mm
85.1mm
116.39mm
41.99mm
To Next Page
Loading...
