Operation and Maintenance
60
Magellan™ 9800i Scanner
Horizontal Scan Window Replacement (DLC)
Diamond-Like Carbon coated (DLC) horizontal scan windows are replaceable. Use the
instructions below to remove and replace the window.
NOTE
Sapphire glass does not require replacement, so it is permanently fastened in
place. Do not attempt to remove Sapphire glass from the platter.
1. Remove the All Weighs™ Platter from the scanner as shown in Figure 37.
2. Turn the platter upside down on a
clean, dry surface and remove the two screws as shown
(#1 in
Figure 39). Retain all screws and nuts for later reinstallation.
3. Lift the edge of the retainer shown (#2 in
Figure 39) and remove it from the assembly.
4. Take note of how the gasket is seated, then gently peel
it away from the assembly. Retain
the gasket (#3 in
Figure 39) for reinstallation.
5. The window (#4 in
Figure 39) can now be removed. Carefully dispose of any damaged
glass.
6. While carefully holding it by its edges, orient the
new horizontal window with the words
“THIS SIDE UP” facing
down (the assembly is upside down at this point), then place the
window into position.
7. Fit the gasket into its channel and press around its entire perimeter to ensure it is fully
sea
ted. Start by pressing in all four corners first.
8. Secure the retainer using the original two screws.
9. Clean both sides of the new horizontal window using a paper towel or lint free cleaning
tissues dampened with a mild, water-bas
ed glass cleaner. DO NOT use abrasive cleaners
or pads.
Reinstall the platter. Gasketed horizontal window
(DLC) replacement is now complete.
Figure 39. Removing/Replacing the Gasketed DLC Window
1
Remove 2 screws
4
DLC Window
2
DLC Retainer
5
All Weighs Platter (inverted view)
3
Gasket
To Next Page
Loading...
