RF Programming Manual 157
RF Beep
Duration
The duration of time that an ACK beep is sounded is selectable using
this setting. RF beep duration can be set in increments of 10 ms (toler-
ance of +/- 10%) from 0 to 2.55 seconds.
Feature is specific to scanner ONLY
SET -------------------------------------------
Set RF Beep Duration ---------
Scan three digits representing the desired duration using the
Number Pad in Appendix C: Keypad on page 193, padded with
leading zeros (example: 008 = 80ms, 025 = 250ms, 100 = 1 sec-
ond, etc.), then scan the END bar code.
END ------------------------------------------
To Next Page
Loading...
