User’s Manual 129
Communications
There is more than one way to connect the Rhino II to a host PC
running Windows. Each requires specific connections in order to
function properly.
Setting Up Ethernet Communications
Ethernet communications usually do not require special
configuration. The Rhino II default settings are configured to use
DHCP to automatically get an IP address from a DHCP server. To
change these settings select Start -> Settings -> Network and
Dialup Connections. Then select DM9CE1 and set the parameters to
work with your network.
NOTE
Windows Embedded CE does not have native support for
allowing direct Network browsing (No "Network
Neighborhood") or for allowing network clients to access
the Rhino II (Rhino II will not show up in "Network
Neighborhood").
To Next Page
Loading...