User’s Manual 139
Troubleshooting the Rhino II
If you send the Rhino II in for service, it is your responsibility to save
the computer data and configuration. Datalogic is responsible only
for ensuring that the hardware matches the original configuration
when repairing or replacing the computer.
Problems While Operating the Rhino II
Problem Solution
You press
Power
and nothing
happens
•
Make sure you are connected to a power
supply.
•
Make sure the brightness is not set all
the way to the darkest or lightest
setting. Press the + key until you reach
the desired brightness level.
•
Make sure you are pressing the Power
button for at least the minimum
duration set in the configuration (default
3 seconds).
•
If the Rhino II will not reboot, contact
Datalogic or your local Datalogic service
representative for help.
To Next Page
Loading...