Getting Started
User’s Manual 15
Resetting the Terminal
There are two reset methods for the Rhino II.
A warm boot terminates an unresponsive application and clears the
working RAM, but preserves the file system. The Registry is restored
from persistent memory if available or returned to factory default.
A clean boot restores the Rhino II to a clean configuration: both the
Registry and the file system returns to a clean status that conforms
to factory default (WEC7 only).
Warm Boot
To perform a warm boot, power down the terminal.
Clean Boot (WEC7 Only)
To perform a clean boot, do the following steps:
1. Launch a DOS prompt in Administrator mode
2. Change directory to \Windows
3. Run CleanBoot.cmd. CleanBoot can take up to 5 minutes, please
wait for the VMC to reboot.
To Next Page
Loading...