Rhino II Configuration
User’s Manual 25
AlphaValue
0 (=Default – no Transparency)
Here values of 10 (almost completely transparent / invisible)
to 250 (almost opaque) are accepted.
TransparentCol
0 (=Default – not transparent respectively invisible color)
Here, a color can be set that is completely invisible in the
output, i.e. the background is completely visible. This will, for
example, be used to produce Window frames round corners
or to paint the icons used regardless of the background color
of the buttons.
Usually, purple is mostly used. The colors are always in RGB
notation, Example: "TransparentCol=255,0,255".
ZoomFactor
Here a maximum 10 zoom values are specified, separated by
commas. The values are always specified as a percentage
(e.g 200 = twice as large as normal).
The starting size of a keyboard is always 100% in accordance
with the key sizes specified in the keyboard definition, etc.
The value 100 must not be specified separately in the Zoom
list - it is automatically inserted at the beginning.
RepeatKeys
0=Off, 1=On (Default), on default the Repeat function is
activated. For special Keyboards with special functions this
Repeat function is mostly not desired.
AutoMove
0=Off (Default), 1=On, allows freely moving Keyboards with
finger. Therefore you must press anywhere on the Keyboard
and immediately start to move (wipe) it around. If this
function is activated, which results in a slight delay (~ 100
ms) when releasing (or pressing) the key. If you tap the key
only briefly, the key function is executed without further
delay on release.
Keyname Parameter – Info
To Next Page
Loading...