Datalogic Rhino II - Section [Keys]

Rhino II Configuration
28 Rhino™ II
Section [Keys]
In this section the general and for all keyboards valid definition for
the layouts of the single keys will be specified.
Max. 40 individual Key-Layouts can be created.
The various fields can be assigned as follows:
Keyname Parameter
KeyName
FontName, BMPNormal, BMPActive, TxtMode, IconMode,
FrmXL,FrmYL, FrmTxtNormL,T,R,B, FrmTxtActL,T,R,B,
FrmIconNormL,T,R,B, FrmIconActL,T,R,B
KeyName
This KeyName can arbitrarily be named. If the key will
be used later on the keyboard, the corresponding
defined
KeyName must be specified.
FontName The Fontname from the [Fonts] section to be used.
BMPNormal Bitmap for normal key display (not pressed).
BMPActive Bitmap for active key display (pressed).
TxtMode
Here the orientation for the text output can be
determined, per default the text will be displayed
always horizontal and vertical centered in the key.
L=left-aligned, R=right-aligned, T=top, B=bottom.
Combinations like e.g. ’LT’ or ’LB’ are allowed.
IconMode Orientation for Icon-Positioning, identical to
TxtMode .
FrmXL, FrmYL
Here special frame values for the allocation of Bitmaps
(
BMPNormal + Active ) can be set to create bigger or
smaller Buttons. Normally it isn’t necessary and the
values should be left empty.