Datalogic Rhino II - Section [Keyboard_Xx]

Rhino II Configuration
30 Rhino™ II
Section [Keyboard_XX]
This section provides the actual definition of the keyboards. Max. 20
Keyboards (XX = 01-20) are possible for each Cfg-File. A Keyboard
Definition is only recognized as valid if at least the line "L01_Norm" is
defined in the section (see description below).
With horizontal screen orientation (Landscape), the default
definitions are read, for example, [Keyboard_01].
In vertical orientation (Portrait-Mode), first the system tries to read
the keyboard definition from the Section [Keyboard_XX_Portrait], for
example from [Keyboard_01_Portrait].
If nothing is defined in the Portrait-Section (at least L01_Norm) or
the section doesn’t exist, the default landscape will be used.
General Settings
Keyname Parameter – Info
Name
Individual Name for the Keyboard. This name can be
shown optional in the Title bar (or can be eventually be
used later to control the keyboards).
DefaultKeyName
Here the KeyName layout from the [Keys] section will be
specified, which will be used for all keys.
DefaultKeySize
XLength,YLength
Standard-Key size for this Keyboard in Pixels.
Position
XPos,YPos
Start position of the keyboard in pixels. Should the
keyboard be moved by the user, this new position is
stored in the registry for each keyboard and used in
subsequent starts.
CloseOnClick
0=Off (Default), 1=On, this mode automatically closes
the keyboard after pressing or executing a button.